Connector Diagram - ELNA 6200 Service Manual

REFER TO THE DIAGRAM FOR LOCATING THE CONNECTOR POST ON THE CIRCUIT
BOARD
TO DISCONNECT THE CONNECTORS:
1. GRASP THE CONNECTOR BODY WITH YOUR FINGERS AND PULL.
DO NOT PULL THE LEAD WIRE, IT MAY DAMAGE THE CONTACT SLEEVES INSIDE THE
CONNECTOR.
2. WHEN DISCONNECTING THE MACHINE SOCKET AND POWER TRANSFORMER CONNECTORS, PULL
THEM WHILE PUSHING THEM TOWARD THE PRINTED CIRCUIT BOARD TO UNLOCK THEM.
TO CONNECT THE CONNECTORS:
1. BE SURE TO CONNECT THE CONNECTORS WITH THE CONNECTOR POSTS OF THE SAME COLOR.
2. POSITION THE CONNECTOR CORRECTLY, THEN PUSH IT STRAIGHT DOWN UNTIL IT LOCKS IN
PLACE.
A: MACHINE SOCKET (SECONDARY CIRCUIT)
B: ZIGZAG WIDTH MOTOR
C: FEED MOTOR
D: DC MOTOR
E: MACHINE SOCKET (PRIMARY CIRCUIT))
F: POWER TRANSFORMER (PRIMARY CIRCUIT))
G: POWER TRANSFORMER (SECONDARY CIRCUIT))
H: BUTTONHOLE SENSOR
I: LAMP
J: BOBBIN WINDER SWITCH
K: UPPER SHAFT SENSOR
L: PRINTED CIRCUIT BOARD "K"

CONNECTOR DIAGRAM

CONNECTOR DIAGRAM CONNECTOR DIAGRAM
CONNECTOR DIAGRAM CONNECTOR DIAGRAM
G
J
H I
K
B
D
F
C
I
H
G
F
E
21
E
K
A
FOR FACTORY
L
B
USE ONLY
C
D