Uniden FP105 Operating Manual page 6

1. Install the battery.
a. Use a Phillips screwdriver to remove the two screws on the battery
compartment cover.
b. Remove the battery compartment cover.
Snap the battery's contacts firmly to the battery connector, then place
C.
the battery inside the compartment.
d. Replace the cover and secure with the screws.
Dispose of old batteries promptly and properly.
Disconnect the telephone line cord before replacing the battery
and always use a new 9V alkaline battery for optimum
performance.
!
Before choosing a location for your phone, please read the Important
Safety Instructions on Page 1.
.
2. Plug one end of the Handset Cord (curly) into the Handset and the other end into the jack
on the side of the telephone.
3. Plug one end of the line cord (straight) into the telephone line jack on the back of the
telephone and the other end into the wall outlet.
Most phone equipment available now use modular jacks.
Phone cords are fitted with a moulded plastic connector which plugs into
this type of jack. If you do not have a modular jack, contact your local
telephone company for information about their installation.
!
Never install telphone wiring during a lightning storm.
l
Never touch uninsulated telphone wires or terminals unless
l
the telephone line has been disconnected.
Use caution when installing or modifying telephone lines.
l