Related Manuals for Uniden FP204
Summary of Contents for Uniden FP204
-
Page 1: Lcd Display
FP204 LCD Display Caller ID Speaker Phone For more exciting new products please visit our website: Australia: www.uniden.com.au New Zealand: www.uniden.co.nz... -
Page 2: Table Of Contents
CONTENTS Introduction ....................1 Features ..................1 Included in your package .............1 Location and Controls ................2 Setup ......................2 Connecting Line Cords and AC Adaptors ........3 Setting Time and Date ..............3 Optional Backup Battery Installation ............3 Telephone Key and Switch Functions ............5 Display Messages ..................6 Caller ID ....................7 Caller ID Operation ..................7 Speed Dial Numbers ................8... -
Page 3: Location And Controls
LOCATION OF CONTROLS Hook switch NEW CALL indicator This unit is not IN USE indicator button button waterproof. Do not phone book delete button button expose this product to Speaker volume Speaker control rain, water, moisture M1~M3 button or any other liquid. dial button store button mute button... -
Page 4: Connecting Line Cords And Ac Adaptors
Connecting Line Cords and AC Adaptor 1. Plug one end of the supplied telephone cord into the telephone line socket located at the rear of the phone. 2. Plug the other end into the telephone line wall jack. 3. Plug the AC Adaptor lead into the power socket at the rear of the phone. 4. - Page 5 Digit Insert 0 Caller ID To correctly display and dial Call ID numbers, you may need to insert a digit at the beginning of your telephone number. (eg: in New Zealand, Telecom requires a '0' to be inserted.) New Zealand: If you subscribe to Telecom New Zealand, this code has already been set for you to '0N'.
-
Page 6: Telephone Key And Switch Functions
TELEPHONE KEY and SWITCH FUNCTIONS Ring Volume (Hi/Lo/Off) Set the ring volume switch to the desired level (Hi, Lo or Off). The maximum level is Hi. The switch is located at the back of the unit. Ring Pitch (Hi/Lo) Set the ring pitch switch to the desired level (Hi or Lo). The switch is located at the back of the unit. -
Page 7: Display Messages
DISPLAY MESSAGES Message Waiting If you have arranged a voice mail service with your telephone company, the LCD screen will display For LCD messages to MESSAGE WAITING for a few seconds after a call is received. The screen will then display in the upper operate, you must first left corner until you retrieve the message from the voice... -
Page 8: Caller Id
CALLER ID A Caller ID record consists of the following information: Time and Date of call Number of new calls or record number Total calls The LCD display will not operate if the AC Adaptor is not connected or if the Caller's number batteries are flat or not Caller's name (if available) -
Page 9: Speed Dial Numbers
SPEED DIAL NUMBERS Three speed dial numbers can be programmed into the memory of your telephone ). Each memory location can store a maximum of 16 digits. Storing One-Touch Speed Dial Numbers A Speed Dial label has 1. Press . The LCD shows STORE -->... -
Page 10: Troubleshooting
Please check with your service provider that your subscription to this service is active. If the screen is blank check the AC adaptor or replace batteries. Please refer to our website for further information and frequently asked questions. www.uniden.co.nz New Zealand - Australia -... -
Page 11: Warranty
Product is; If a warranty claim is made, this warranty will not apply if the Product is found by Uniden to be: (A) Damaged or not maintained as reasonable and necessary, (A) Damaged or not maintained in a reasonable manner or as recommended in the relevant Uniden (B) Modified, altered or used as part of any conversion kits, subassemblies, or any Owner’s Manual;... - Page 12 © 2011 Uniden Australia Pty Limited Uniden New Zealand Limited...