Setting Up Your Answering System - Uniden WDECT3355 Owner's Manual

• When the
answering system
is full, FL appears
on the base. You
should delete
some messages
so that the system
can record new
messages.
• Position yourself
as near to the base
as possible and
speak clearly when
recording your
outgoing message.
• If you make an
outside call, or a
call is received on
the base during
the operation,
the operation is
canceled.
[ 43 ]

SETTing up yOur anSWEring SySTEM

Setting your outgoing message (Greeting)
When you receive a call, the answering system automatically plays either the pre-
recorded message or your own personal message (greeting).
Pre-recorded message
The following message is pre-recorded:
"Hello, no one is available to take your call. Please leave a message after the tone."
recording a personal outgoing message (Greeting)
You can record a greeting up to 30 seconds long (must be more than 2 seconds
long).
1) When the phone is in standby mode, press and hold greeting.
2) Start your recording after the announcement "Record greeting."
The message counter displays "- -", then begins to count down.
3) When you have finished recording your greeting, press greeting, SET, or
play/stop.
You will hear a confirmation tone and your recorded greeting plays back for you.
Choosing between the two outgoing messages
When the phone is in standby mode, press greeting. Press greeting again when
the outgoing message is played. Each time greeting is pressed, the outgoing
message is switched between the pre-recorded and the personal outgoing
message.
Deleting an outgoing message
To delete the personal outgoing message, press
playing. The system announces "Greeting has been deleted."
Setting the base ringer volume
Your base unit has four ringer options, 3 will display for high, 2 for medium, 1 for
low and 0 for off.
delete while the message is