Windows 8.1 - Furuno VR-7000 Instruction Manual

7. Enter the IP address and subnet mask of the PC:
For data extraction from the DCU
• Port J502 (DATA) of the DCU is connected to port J17:
IP address: 172.31.16.201 or 172.31.16.202
Subnet mask: 255.255.0.0
Note: The IP address of the VR-7000/7000S is 172.31.16.200.
• Port J502 (DATA) of the DCU is connected to port J26:
IP address: 10.0.0.101 or 10.0.0.102
Subnet mask: 255.0.0.0
Note: The IP address of the VR-7000/7000S is 10.0.0.100.
For data extraction from the DRU
IP address: 10.0.0.102 or 10.0.0.99 (other than 10.0.0.140 and 10.0.0.150)
Subnet mask: 255.0.0.0
8. Click the [OK] button and then click the [Close] button.
9. Restart the PC.
1.2.2 Windows
Install the software
1. Insert the supplied program CD into the CD drive.
2. Run "view.exe" on the program CD to show the [Setup-VR-7000] dialog box.
3. Click the [Next] button.
4. Confirm that the install location is "C:\Program Files*\FURUNO" then click the [Next] button.
* Folder name for 32 bit. "Program Files(x86)" for 64 bit.
5. Click the [Yes] button.
6. Click the [Next] and [Install] buttons to install the software.
7. After the installation is completed, the message "Yes, restart computer now" is checked. Click
the [Finish] button to complete the installation and restart the PC.
Set the IP address and subnet mask
1. Move the mouse cursor to the bottom or top right corner of the screen and select the cog icon
for [Settings].
2. Select [Control Panel].
3. In the [Control Panel] window, select [Category] and then select Large or Small icons.
4. Select [Network and Sharing Center].
5. Select [Change adapter settings].
6. Right click on your connected network and select [Properties].
7. Select [Internet Protocol Version 4 (TCP/IP v4)] then click [Properties].
8. Click the [Use the following IP address] button.
®
8.1
3
1. INSTALLATION