Adjustment - Kenwood TK-8180 Series Service Manual

TK-8180/8189
Controls
Power Volume
switch Up/Down key
Modular Programmable
MIC jack function keys
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press [A] key and turn power on. Hold [A] key until fre-
quency version appears on LCD. Test mode can be inhib-
ited by programming. To exit test mode, switch the power
on again. The following functions are available in test mode.
■ Key operation
Key
Function
[S] Shifts to Panel tuning mode
[A] Function on
[B] MSK 1200bps and 2400bps
[C] Test signaling CH up
[ ]/[ ] Test frequency CH up/down
[ ]/[ ] Volume up/down
[ ] Squelch on/off
[■ ] Narrow/Wide 4k/Wide 5k
[0] to [9] Use as the DTMF keypad.
and [#], If a key is pressed during
[✳] *1 transmission, the DTMF
corresponding to the key
that was presses is sent.
Microphone key
[PTT] Transmit
[0] to [9] Use as the DTMF keypad.
and [A], If a key is pressed during
[B], [C], transmission, the DTMF
[D], [#], corresponding to the key
[✳] that was presses is sent.
*1 : TK-8189 model only
40

ADJUSTMENT

Channel
LCD Up/Down key
12-key
(TK-8189
model only)
"FNC" not appears
Display
-
"FNC" appears
2400bps : icon appears
Signaling No.
Channel No.
-
Narrow : "n",
Wide 4k : "s",
Wide 5k : "w"
-
-
-
Key
Function
[S] High power / Low power
[A] Function off
[B] Compander on/off
[C] Beat shift on/off
[ ]/[ ] Function off
[ ]/[ ] Function off
[ ] Squelch level 0
[■] LCD all lights
[0] to [9] and Function off
[#], [✳] *2
Microphone key
[PTT] Transmit
[0] to [9] and Function off
[A], [B], [C],
[D], [#], [✳]
*2 : TK-8189 model only
Note : If a [S], [A], [B], [C] key is pressed during transmission,
the DTMF corresponding to the key that was pressed is sent.
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• Sub LCD indicator
"FNC" Appears at function on.
• LCD display in panel test mode
n 1
n : Narrow
Channel No.
s : Wide 4k
w : Wide 5k
■ Frequency and Signaling
The set has been adjusted for the frequencies shown in
the following table. When required, readjust them following
the adjustment procedure to obtain the frequencies you want
in actual operation.
• Test frequency
CH RX (MHz) TX (MHz)
1 435.05000 435.10000
2 400.05000 400.10000
3 469.95000 469.90000
4 435.00000 435.00000
5 435.20000 435.20000
6 435.40000 435.40000
7~16 -
"FNC" appears
Display
Low : icon appears
-
On : icon appears
On : icon appears
-
-
On : icon appears
LCD all point appears
-
-
-
– 1
Signaling No.
-