Table 6-3 Configuration Module Kit P/N 011-00979-03 (P1001)
Figure 6-6
Reference
1
Configuration Module, PCB Board Assembly w/EEPROM
3
4-Conductor Harness
4
Pin Contact, Crimp, #22D
Figure 6-6 Backshell Assembly (Potted Configuration Module)
Removal
1. Disconnect the connector (5) from the GTN Xi backplate assembly.
2. Remove two screws (8) from cover (7) and remove cover.
3. Unplug the connector from the configuration module (1).
4. Remove the configuration module from the backshell (6).
Re-installation
1. Inspect the connector for damaged pins (4) or wires (3).
2. Place the configuration module (1) in position.
3. Insert connector into the configuration module (1).
4. Place the cover (7) back on the connector and re-install screws (8).
190-01007-C1
Rev. 1
Description
GTN Xi Part 23 AML STC Maintenance Manual
Garmin P/N
011-02178-00
325-00122-00
336-00021-00
Page 6-13