Table of Contents
Advertisement
14. When the heat exchanger is latched, make sure that there is a tight fit between
15. With the rear door closed and latched, move to the front of the rack. Use a
16. Attach the hoses and fill the heat exchanger with water. See "Filling the heat
17. After you attach the hoses and fill the heat exchanger with water, complete the
Figure 60. Installing the inner hose access panel
74
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
the heat exchanger and the rack frame. Loosen or tighten the latch adjustment
screw as required.
leveler wrench to raise the right front leveler approximately 3 mm (0.12 in.) or
until the rear door opens and closes freely. Periodically check that the rear
door swings freely. If necessary, adjust the height of the right-front leveler until
the rear door does swing freely.
exchanger with water" on page 48.
following steps:
a. Install the inner hose access panel on the inside bottom of the heat
exchanger.
Inner hose
access panel
Advertisement
Table of Contents
