Table of Contents
Advertisement
Chapter 3. Special instructions if the heat exchanger comes
installed on a rack
To unpack a rack with a rear door heat exchanger, see the IBM 42U 1100 mm
Enterprise V2 Dynamic Rack and Expansion Rack and IBM PureFlex System 42U
Rack and Expansion Rack Unpacking Instructions document that comes with the
rack or to download the document from the IBM website, go to
http://www-947.ibm.com/support/entry/portal/docdisplay?lndocid=migr-5091922.
If the rack was unpacked without using the instructions in the Rack Unpacking
Instructions document, you might have to perform the following steps:
1. Make sure that the foam block that is under the left side of the rear door heat
Figure 11. Removing the foam block
© Copyright IBM Corp. 2011, 2013
exchanger is removed.
23
Advertisement
Table of Contents
