IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual page 36

4. After you attach the hoses and fill the heat exchanger with water, complete the
Figure 13. Installing the inner hose access panel
Figure 14. Installing the outer hose access panel
26
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
following steps:
a. Install the inner hose access panel on the inside bottom of the heat
exchanger.
Inner hose
access panel
b. Install the outer hose access panel on the outside bottom of the heat
exchanger.
c. (Optional) Secure the outer hose access panel to the heat exchanger with
an M4 screw (see Figure 14).
d. Reconnect power to the rack and all components; then, close and latch the
heat exchanger.
Optional
screw
Outer hose
access panel