Table of Contents
Advertisement
3. Route the hoses through the access hole lengthwise, under the rack and around
Figure 35. Flexible hoses secured to the bottom of the rear door heat exchanger
After several hours of operation, repeat the air-purging procedure on the valve
(trapped air from the hoses might have migrated to the heat exchanger). To perform
the air-purging procedure, complete step 7 on page 52 through step 10 on page 52
in Filling the heat exchanger with water.
Check the heat exchanger for air in the manifolds again after one month of
operation, to ensure that the heat exchanger is filled correctly. For
46
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
the rear caster on the pivot side of the heat exchanger. See "Filling the heat
exchanger with water" on page 48 for information about how to connect the
hoses.
Advertisement
Table of Contents
