IBM Rear Door Heat eXchanger V2 Installation And Maintenance Manual page 50

25. Install the lower air baffle in the rear of the rack. Secure the air baffle to the
Figure 27. Installing the lower air baffle
26. With the rear door closed and latched, move to the front of the rack. Use a
27. Attach the hoses and fill the heat exchanger with water. See "Routing and
28. After you attach the hoses and fill the heat exchanger with water, complete the
Figure 28. Installing the inner hose access panel
40
Rear Door Heat eXchanger V2: Installation and Maintenance Guide
rack with four M6 screws.
Lower air baffle
leveler wrench to raise the right front leveler approximately 3 mm (0.12 in.) or
until the rear door opens and closes freely. Periodically check that the rear
door swings freely. If necessary, adjust the height of the right-front leveler until
the rear door does swing freely.
securing the hoses" on page 44 and "Filling the heat exchanger with water" on
page 48 for information about routing and attaching the hoses and filling the
heat exchanger.
following steps:
a. Install the inner hose access panel on the inside bottom of the heat
exchanger.
Inner hose
access panel
Screws
Sliders
Screws