Table of Contents
Advertisement
12. Using a utility knife or similar cutting tool, slit the heat exchanger carton
vertically on each end of one of the long sides of the carton. See the
illustration. Fold down the carton to cover the floor surface.
Figure 22. Folding down the carton and placing the packing inserts evenly on the unfolded
cardboard
13. Place three of the rectangular cardboard packing inserts evenly on the
unfolded cardboard. See Figure 22.
CAUTION:
or
The weight of this part or unit is between 32 and 55 kg (70.5 and 121.2
lb). It takes three persons to safely lift this part or unit. (C010)
Attention:
a. Because of the size and weight of the heat exchanger, three trained
persons are required to install or remove the heat exchanger.
b. You must remove the power from the rack and all components before you
connect or disconnect the water supply lines and drain or fill the heat
exchanger.
>32 kg (70.5 lb)
32-55 kg (70.5-121.2 lb)
or
Chapter 4. Installing the heat exchanger
35
Advertisement
Table of Contents
