Chirp Delete - Ultra Start 430 Series Install Manual

Double Pulse Unlock
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#2 - #2 then #1.
3 - The siren will respond with the following:
Voltage / Door Pin Sensing
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #1 then #3
3 - The siren will respond with the following:

Chirp Delete

To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#2 - #2 then #1
3 - The siren will respond with the following:
Shock Sensor Disable
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#3 - #3 then #1
3 - The siren will respond with the following:
Repeat sequence to change selection
1 Chirp Double Pulse Unlock
2 Chirps Single Pulse Unlock
Repeat sequence to change selection
1 Chirp Voltage Sensing- No Door Pin Connection Needed
2 Chirps Door Pin- Door Pin Connection Required
Repeat sequence to change selection
1 Chirp Chirps Disabled
2 Chirps Chirps Enabled
Repeat sequence to change selection
1 Chirp Shock Sensor OFF
2 Chirps Shock Sensor ON