Connecting To The Console Port; Connecting To A Power Source - Delta Agema Series Installation Manual

3.3

Connecting to the Console Port

This port is used to connect a console device to the switch through a nullmodem serial cable.
The console device can be a PC or workstation running a VT-100 terminal emulator, or a VT-
100 terminal.
NOTE:
An RJ-45-to-DB-9 cable is not supplied with the switch for connecting to a PC's
RS-232 serial DB-9 DTE port.
3.4

Connecting to a Power Source

3.4.1 Installing an AC Power Supply
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket of a PSU located at the back of the
switch.
2. Plug the other end of the cable into a grounded, 3-pin, AC power source.
NOTE:
For International use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the socket type in your country.
RJ-45 connector
DB-9 port
(Figure 3-7: Console Port Connection)
(Figure 3-8: Power Socket)
15
Power socket
Chapter 3 • Installation