Connecting To The Console Port; Connecting To A Power Source - Delta Agema Series Installation Manual

3.4

Connecting to the Console Port

This port is used to connect a console device to the switch through a null modem serial cable.
The console device can be a PC or workstation running a VT-100 terminal emulator, or a
VT-100 terminal.
NOTE:
An RJ-45-to-DB-9 cable is not supplied with the switch for connecting to a PC's
RS-232 serial DB-9 DTE port.
3.5

Connecting to a Power Source

3.5.1 Installing an AC Power Supply
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket of a PSU located at the back of the
switch.
2. Plug the other end of the cable into a grounded, 3-pin, AC power source.
NOTE:
For International use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the socket type in your country.
3. Check the PSU and front-panel LEDs as the device is powered on to be sure that AC
power is being received and the PWR1 LED is on. If not, check that the power cable is
correctly plugged in.
RJ-45 connector
DB-9 port
(Figure 3-6: Console Port Connection)
(Figure 3-7: Power Socket)
15
Chapter 3 • Installation
Power socket