Power Supply Modules - Delta Agema Series Installation Manual

Aggregation switch
Hide thumbs Also See for Agema Series:
Table of Contents

Advertisement

2.5

Power Supply Modules

The power supply modules are hot-swappable power supply units (PSUs) for the switch.
You can install up to two PSUs. The PSUs operate in a load-sharing mode and provides 1+1
redundancy.
NOTE:
1+1 redundancy is a system where a switch power supply is backed up by
another switch power supply in a load-sharing mode. If one power supply fails,
the other power supply takes over the full load of the switch.
WARNING:
AVERTISSEMENT:
(Figure 2-7: Power Supply Unit)
The switch includes plug-in power supply and fan tray modules that are
installed into its chassis. All modules have a front-to-back airflow direction.
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
Remove the power cable from the module prior to removing the module
itself. Power cable must not be connected prior to insertion in the chassis or
equivalent.
Le commutateur comporte des modules de bloc d'alimentation enfichable
et de cassette de ventilation dans son châssis. La circulation d'air se fait de
l'avant vers l'arrière dans tous les modules.
Risque d'explosion si la pile est remplacée par une de type différent. Suivez
les instructions pour éliminer les piles usées.
Débranchez le câble d'alimentation du module avant de retirer ce dernier. Le
câble d'alimentation ne doit pas être branché avant l'insertion des modules
dans le châssis ou ailleurs.
Chapter 2
9
Appearance and Mechanism

Advertisement

Table of Contents
loading

This manual is also suitable for:

Agema agc7648s v1 seriesAgema agc7648s v1Agema agc7648sl v1

Table of Contents