Type Plate; Product Overview And Description; Operating Principle Of Adsorption Dryer; Prefilter With Condensate Drain - Beko DRYPOINT AC Series Installation And Operating Manual

EN

2.2. Type plate

The type plate is attached to the container of the DRYPOINT
NOTE Handling of type plate
Do not remove or cover the type plate, and protect it against damage.

2.3. Product overview and description

2.3.1. Operating principle of adsorption dryer

2.3.1.1. Prefilter with condensate drain

The medium to be dried is pre-filtered by a high-performance submicro filter. Oil, water and dirt particles are held
back by the micro-fibre fleece to a rate of 99.99998% for dirt particles larger than 0.01 µm.
The micro-fibre fleece is encased in a coalescing filter jacket and the medium flows from the inside outwards. In the
coalescing filter, the liquid aerosols and mists form larger droplets, which then drop into the bottom part of the filter
housing from where they are removed through the condensate drain from the system.
After the prefiltration stage, the residual oil content is smaller than 0.01 mg/m
3 mg/m ).
3

2.3.1.2. Afterfilter

The downstream dust filter removes fine dust with a particle size of < 25 µm from the compressed air.
DRYPOINT AC 410 – 495 | DRYPOINT
®
Manufacturer:
BEKO TECHNOLOGIES GmbH
Im Taubental 7
D-41468 Neuss
Art-Nr.
Item number
N° d´article
xxxxxxxxxx
Anlage
Plant
Installation
DP AC xxxx
Betriebsdruck
Operating pressure
Pression de fonctionnement
min. 4 bar / max. 16 bar
Vorfilterelement
Prefilter element
Element du filter amont
1. xxx
2. N/A
3. N/A
Schutzklasse / Schutzart
Protection class / Type of protection
Classe de protection / Type de protection
I / IP54
AC 410 – 495 MS
®
AC.
®
Serien-Nr.
Serial-no.
N° de serie
xxxxxxxxxxx
Baujahr
Year of manufacture
Anne de fabrication
xx / 20xx
Spannung / Leistungsaufnahme
Voltage / Power consumption
Voltage / Consommation électrique
230 V - 50-60 Hz / 40 W
Betriebstemperatur
Operating temperature
Temperature de service
min. 5 °C / max. 50 °C
Umgebungstemperatur
Ambient temperatur
Temperature ambiente
min. 4 °C / max. 50 °C
Nachfilterelement
Afterfilter element
Element du filtre à poussieres
xxx
(at a max. infeed concentration of
3
Installation and operating manual
15