Depressurising Plant; Dismantling And Disposal - Beko DRYPOINT AC Series Installation And Operating Manual

Installation and operating manual

9.1. Depressurising plant

WARNING Blow-off noises during pressure release
When compressed gas is released, it expands, which might result in a loud noise.
•
1. Shut down the plant, following the relevant instructions (see also "9. Shutting down plant").
2. Close the shut-off fittings A and B (see figures "Bypass line" on page 35).
3. Press and hold the TEST button of the BEKOMAT
completely depressurised.

10. Dismantling and disposal

NOTE Safe disposal of plant components
•
Dismantle the components and dispose of the various materials through the appropriate recycling channels.
The adsorbent must be disposed of according to special safety regulations. For instructions, contact the
manufacturer's customer service department, who will perform this task for you.
50
Therefore always wear hearing protection!
All plant components, materials and substance must be disposed of safely and in
accordance with the applicable statutory waste disposal regulations.
until all condensate is discharged and the plant is
®
DRYPOINT AC 410 – 495 | DRYPOINT
®
EN
AC 410 – 495 MS
®