Stihl FS 240 Service Manual page 89

1
: Slide throttle trigger (1) onto
post (3)
: Slide lever (2) into the throttle
trigger (1) so that the lever
(arrow) rests against the stud
1
: Turn the trigger interlock (1)
slightly and push the throttle
trigger on further until it engages
the trigger interlock
1
: Slide torsion spring (1) onto
throttle trigger and secure it with
the anchor loop on the cylindrical
raised part (arrow)
88
2
3
: Turn torsion spring clockwise and
hook it into the lever (arrow)
Ground wire and short circuit wire
must be inserted completely in the
guides (arrows).
2
: Route throttle cable (1) and
protective tube (2) in the guides
(arrows) and hold in place
– Carefully fit handle molding (1)
: Insert and tighten down the
Checking operation
1
When the trigger interlock (1) is not
pressed, the throttle trigger (2) is
blocked and must not move.
: Release throttle trigger (2) – the
FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
1
until it snaps into place
– Levers may pop out
screws (arrows)
1
2
throttle trigger must return
completely to the stop