Stihl FS 240 Service Manual page 131

No. Designation
9 Assembly drift
10 Combination wrench
11 Installing sleeve
12 Press arbor
13 Installing tool
14 Clamping device for assembly
stand
15 ZAT 4 ignition tester
16 ZAT 3 ignition tester
17 Torque wrench
18 Torque wrench
19 Installing tool, 11
20 Bit T 27 x 150
21 Assembly stand
22 Puller
- Jaws (with profile no. 3.1)
23 Assembly hook
Remarks:
1) Use only for releasing.
130
Part No. Use
1110 893 4700 Removing and installing piston pins
1129 890 3401 Spark plug
4119 893 4600 Protection of the oil seal
(Starter side)
4119 893 7200 Cold forcible insertion of starter side
ball bearing
4126 893 4900 Rubber element 1-point antivibration
system
5910 890 8800 Clamping drive tube assembly of
machine to assembly stand
5910 850 4503 Test ignition system
5910 850 4520 Test ignition system
5910 890 0302 Screw connections (0.5 to 18 Nm)
5910 890 0312 Screw connections (6 to 80 Nm)
5910 890 2211 Fit hookless snap rings in piston
5910 890 2400 IS-P screws (4 mm)
5910 890 3101 Holding machine for repairs
5910 890 4400 Extracting the oil seal
0000 893 3706 Extracting oil seal(s)
5910 893 8800 Remove pick-up body
FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
Re-
marks
1)