Stihl FS 240 Service Manual page 51

: Hook throttle cable (1) onto
lever (2) and press grommet into
the mount (arrow)
3
2
4
: Orient throttle cable so that short
circuit wire (1) and ground
wire (2) face the cable holder
: Position Bowden cable (3) in the
guide (arrow) and guide
protective tube under the tab (4)
1
: Position protective tube (1) of the
throttle cable in the guide of the
clutch housing so that it is aligned
with the edge (arrow) of the cable
holder
50
As strain relief, the protective tube is
clamped between the tab of the
2
cable holder and the guide of the
clutch housing.
1
– Hold the cable holder with throttle
cable in this position
– Pull the red and black lead of the
M-Tronic out of the guides
again up to the throttle cable
1
2
1
: Screw in screw (1)
– do not tighten
: Check orientation and position of
the protective tube (2), align if
necessary, and tighten screw (1)
3
: Position ground wire (1) of the
short circuit wire and ground
wire (2) of the M-Tronic with the
connector tags (arrows) in the
recess
: Screw in screw (3)
– do not tighten
3
: Starting at the connector tags,
press ground wire (1) of the short
circuit wire and ground wire (2) of
the M-Tronic into the
guides(arrows) as far as they will
go
: Tighten screw (3)
FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
2
1
2
1