Table of Contents
Advertisement
10. TEST DOOR SYSTEM
A. OPERATING SEQUENCE
Tightly close the door. When swinging the door shut, a
clicking sound assures the door is closed and secure.
Check that door latch engages the latch receptor.
Close drain and begin filling bath.
The door seal will inflate automatically after the two
water level sensors inside the bath near the bottom of
the door are covered with water.
Monitor outside of door for any signs of leaks and
continue to fill bath to a water level at least 2" above the
top of the highest jet.
Open drain and allow bath to empty.
The door seal will automatically deflate when water level
lowers below the water level sensors.
Press in the button on top of the door and open door
inward.
B. TROUBLESHOOT DOOR SYSTEM
This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or a qualified electrician
should correct all electrical problems. For warranty service, contact your dealer or wholesale distributor.
SYMPTOMS
1. Door won't close.
2. Door won't open.
3. Door leaks water.
4. Compressor runs
periodically.
periodically
CA
113019-
(1093)
PROBABLE CAUSES
A. Seal is out of track.
B. Seal remains inflated.
C. Improper installation.
A. Tub is not empty.
B. No power to unit.
C. Compressor controller.
A. No power to unit.
B. Incorrect field wiring.
C. Seal is leaking.
D. Compressor controller.
A. Seal is leaking air.
B. Faulty pressure switch.
Latch
Button
RECOMMENDED ACTION
A. Re-insert seal.
B. Contact dealer/installer.
C. Contact dealer/installer.
A. Wait for tub to empty.
B. Reset breaker.
C. Contact dealer/installer.
A. Reset breaker.
B. Contact dealer/installer.
C. Contact dealer/installer.
D. Contact dealer/installer.
A. Contact dealer/installer.
B. Contact dealer/installer.
12
Water
Line
2" Min.
Bath Jet
Suction
Kohler Co., Kohler WI
Advertisement
Table of Contents
