Daily Maintenance For The Tornado - TurboChef Tornado Owner's Manual

1
6

DAILY MAINTENANCE FOR THE TORNADO

When cleaning the oven, use only TurboChef
Oven Cleaner. Any other cleaning products can
damage critical parts, resulting in a non-warranty
service call.
Supplies and Equipment
TurboChef Oven Cleaner (P/N 103180 USA,
103380 Intl), Oven Guard (P/N 103181 USA,
103381 Intl), nylon scrub pad, cleaning towel
Step 1: Prepare the Oven
Turn oven off by pressing the
The oven will display
attempt to clean oven during the cool
D O N O T
x
down cycle. Cooling takes appx. 90 minutes.
: The oven operates at appx. 500 º F
WARNING
(260 º C) and may cause injury if not allowed
time to cool properly.
Step 2: Remove the Lower Access Panel
Wipe out any crumbs that have collected.
Step 3: Remove and Clean the Cooking Surface
If rack, wash, rinse, and sanitize.
If baking stone, gently
gets wet, let it thoroughly air-dry.
Step 4: Lift Bottom Element
Be sure the bottom element is cool prior to lifting.
: The bottom element operates at
WARNING
appx. 1000 º F (537 º C).
Step 5: Remove Particles and Spray Oven Interior
with TurboChef Oven Cleaner
®
2
7
key.
BACK
/
OVEN OFF COOLING DOWN
dry-scrub. If the stone
MAINTENANCE AND TROUBLESHOOTING
3 4
8 9
Using a damp towel, remove large food particles.
If stubborn stain is present, sparingly spray
TurboChef Oven Cleaner onto the stain.
Allow cleaner to penetrate for five (5) minutes.
saturate the bottom of the oven with
D O N O T
x
water or oven cleaner.
Step 6: Clean Oven Interior
Using a nylon scrub pad, clean the oven door
and cook cavity.
:
C A U T I O N DO NOT
wave guide covers. Breaking will result in a
non-warranty service call.
.
Step 7: Wipe Out Oven Interior
Wipe oven door, bottom element, and cook
cavity using a damp towel.
Step 8: Clean Lower Access Panel Area
spray any chemical in this area or into
D O N O T
x
any other openings in the oven, such as the
louvers in the side panels or the cooling fan on
the back cover. Doing so will damage critical
electrical components and result in a non-
warranty service call.
Step 9: Lower the Bottom Element and Reinstall the
Cooking Surface and Lower Access Panel
Step 10: Apply Oven Guard and Clean Oven Exterior
Spray Oven Guard on towel. Wipe sides of cook
cavity and inside of door.
spray Oven Guard directly into cook
D O N O T
x
cavity or wipe on nozzle plates/bottom element.
Wipe the oven exterior with a clean, damp towel.
Oven is ready to turn on.
5
10
apply pressure to the
25