Power Supply Cord Replacement; Rf Interference Considerations - TurboChef Tornado Owner's Manual

iii INTRODUCTION

POWER SUPPLY CORD REPLACEMENT

If the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard.
WARNING: Improper grounding can result in a risk of electric shock.

RF INTERFERENCE CONSIDERATIONS

The Tornado oven generates radio frequency signals. This device has been tested and was determined to
be in compliance with applicable portions of FCC part 18 requirements and the protection requirements
of Council Directive 89/336/EEC on the approximation of the laws of the member states relating to
electromagnetic compatibility at the time of manufacture. However, some equipment with sensitivity to
signals below these limits may experience interference.
If your equipment experiences interference, the following steps should be considered:
Increase the physical separation between this oven and the sensitive equipment.
If the sensitive device can be grounded, do so following accepted grounding practices.
If battery-powered microphones are being affected, ensure that the batteries are fully charged.
Keep sensitive equipment on separate electrical circuits if possible.
DO NOT route intercom wires, microphone wires, or speaker cables near the oven.
x
SAVE THESE INSTRUCTIONS