TurboChef Tornado Owner's Manual page 37

Table 1: Error Codes/Faults, Possible Causes and Suggested Remedies
The following is a list of fault codes and error messages, along with the possible problem(s) that the oven
may be experiencing. Please attempt the recommended action before calling Customer Service.
NOTE: Any fault codes listed in bold will terminate a cook cycle upon discovery. F6 will not terminate a
cook cycle; however, it will alert the user of a possible air circulation problem.
ISSUE
No power to oven.
Oven is not warming
up properly.
Display reads
"Oven Door Open"
and alarm sounds.
Oven is not
cooking properly.
*For Customer Service, call 800.90 TURBO/+1 214-379-6000 or your Authorized Distributor.
POSSIBLE CAUSE(S)
Oven is not plugged in.
Main circuit breaker is tripped.
Oven is in state.
OFF
Door is not closed.
Oven has been switched off at
the main circuit breaker.
Oven door is open.
Door switches are out of
alignment.
Oven is not clean. (Large
deposits of grease, carbon, or
food debris dilute the
microwave.)
Incorrect Group and/or
Item name was selected for
the product.
Product was not cooked from
correct starting state (for
example, chilled or frozen).
MAINTENANCE AND TROUBLESHOOTING
RESOLUTION
Plug oven in.
Verify wall circuit breaker is on.
Reset breaker and then power oven
back on.
Press the soft key.
OVEN ON
Close the cook cavity door.
Press the key until the oven
BACK
is in the state – leave for two (2)
OFF
minutes. Unplug the oven – leave for
two (2) minutes. Re-plug in the oven,
switch on the isolator/main power
supply, and press the
key.
Open and close the door several times.
Call Customer Service.*
Clean the oven following the cleaning
instructions on page 25.
Check to make sure correct food
group and/or item was selected for the
product being cooked.
Ensure product was in the correct
state before being placed in the oven.
soft
OVEN ON
27