Cadillac XT4 Owner's Manual page 49

48 SEATS AND RESTRAINTS
3. Start the vehicle with the initial
key or RKE transmitter. The DIC
should display the driver number
of your RKE transmitter.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY.
A DIC welcome message may
indicate driver number 1 or 2.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep
will sound.
4. Immediately press and hold the
1 or 2 memory button matching
the above DIC welcome message
until two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be
saved and two beeps will not
sound. Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See Identifying Driver
Number previously in this
section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for
Exit Memory features, repeat Steps 1
4 using . This saves the position for
getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or
previously saved memory positions if
you are driver 1 or 2 identified in the
DIC welcome message.
To stop Manual Memory recall
movement, release 1, 2, or
any of the following controls:
Power seat
Memory SET
Power mirror, with the driver or
passenger side mirror selected
Power steering wheel, if equipped
Manual Memory recall movement for
1, 2, or
and Seat
and may complete to the saved
memory position if the vehicle is in or
out of P (Park).
Seat Entry Memory
The vehicle identifies the number of
the current driver's RKE transmitter
(1 8). See Remote Keyless Entry (RKE)
System Operation 0 8. If the RKE
transmitter is 1 or 2, and Seat Entry
Memory is enabled in vehicle
to recall the
personalisation, the positions saved to
the same memory button number 1 or
2 are automatically recalled when the
vehicle is turned on, or turned from
off to ACC/ACCESSORY. RKE
transmitters 3 8 will not provide
automatic memory recalls.
or press
buttons may be initiated