Cadillac XT4 Owner's Manual page 293

292 VEHICLE CARE
9. Power Plug
10. Air Only Hose
If a tyre goes flat, avoid further tyre
and wheel damage by driving slowly
to a level place. Turn on the hazard
warning flashers. See Hazard Lights
0 136.
See If a Tyre Goes Flat 0 285 for other
important safety warnings.
1. Remove the compressor from its
storage location. See Storing the
Tyre Sealant and Compressor Kit
0 293.
2. Remove the air only hose (10)
and the power plug (9) from the
bottom of the compressor.
3. Place the compressor on the
ground near the flat tyre.
Make sure the tyre valve stem is
positioned close to the ground so
the hose will reach it.
4. Remove the valve stem cap from
the flat tyre by turning it
anticlockwise.
5. Attach the air only hose (10) to
the tyre valve stem by turning it
clockwise until tight.
6. Plug the power plug (9) into the
accessory power outlet in the
vehicle. Unplug all items from
other accessory power outlets.
See Power Sockets 0 100.
Do not pinch the power plug
cord in the door or window.
7. Start the vehicle. The vehicle
must be running while using the
air compressor.
8. Press the on/off button (5) to
turn the tyre sealant and
compressor kit on.
The compressor will inflate the
tyre with air only.
9. Inflate the tyre to the
recommended inflation pressure
using the pressure gauge (8). The
recommended inflation pressure
can be found on the Tyre and
Loading Information label. See
Tyre Pressure 0 273.
The pressure gauge (8) may read
higher than the actual tyre
pressure while the compressor is
on. Turn the compressor off to
get an accurate pressure reading.
The compressor may be turned
on/off until the correct pressure
is reached.
Caution
If the recommended pressure
cannot be reached after
approximately 25 minutes, the
vehicle should not be driven farther.
The tyre is too severely damaged
and the tyre sealant and
compressor kit cannot inflate the
tyre. Remove the power plug from
the accessory power outlet and
unscrew the inflating hose from the
tyre valve.