Error Codes - True Fitness Z5 Series Owner's Manual

Error Codes

: C
eIGht are and
E1:INCLINE
E1:RANGE
E1:STALL
E2:OVERSPEED
E2:CAL
E3:RECAL
E4:KEY STK [stop] Caused by pressing and holding the
E5:SENSOR
All errors require service by a qualified technician. To clear the error,
turn power off and back on again.
Z 5 S e r i e s T r e a d m i l l O w n e r ' s G u i d e
0
m
aIntenanCe
Incline moving when not commanded to.
Difference between zero position and
maximum incline not sufficient.
Incline not moving when commanded to.
This error occurs when an acceleration of
greater than 2.1 mph occurs. Error cleared
by turning off power switch then turning
it back on.
Treadmill cannot achieve target speed.
Re-calibrate treadmill.
This error occurs when a data error is
detected in the EEPROM. Replace the
control panel.
key for more than five seconds.
This message is displayed when there is
no speed feedback.
e
rror
C
odes