Removing The Front Panel Assembly - JVC TH-A10 Service Manual

TH-A10

Removing the front panel assembly

Prior to performing the following procedure, remove
the top cover, the rear cover and the side covers.
1. Disconnect the harness from connector CN802 on
the main board on the upper side of the body.
2. Remove the two screws C on the upper side of the
body.
3. Remove the three screws D on the bottom of the
body.
4. Release the five joints c and detach the front panel
assembly toward the front.
Joint c
Front panel assembly
1-6
(See Fig. 6 to 9)
Fig.9
C
Joint c
CN802
Front panel assembly
Fig.6
Front panel assembly
D
Joint c
Fig.7
Front panel assembly
Fig.8
C
Joint c
D
Joint c