Removing The Power Switch Board - JVC TH-A10 Service Manual

Removing the power transformer assembly
Prior to performing the following procedures, remove
the top cover and the rear cover.
1. Disconnect the harnesses from connector CN911
and CN912 on the power board.
2. Remove the two screws M
transformer assembly.
3. Remove the screw E
transformer assembly on the back of the body.
Removing the main board (See Fig.26)
Prior to performing the following procedure, remove
the top cover, the rear cover, the front panel
assembly, the rear panel, the DVD mechanism
assembly, the power board and the sub board.
1. Remove the four DVD spacers on the upper side of
the main board.
2. Remove the five screws N attaching the main board.
<Front panel assembly>
Prior to performing the following procedure, remove
the top cover, the rear cover, the side covers and the
front panel assembly.

Removing the power switch board

1. Dithe harness from connector CN705 on the power
switch board.sconnect
2. Remove the three screws O attaching the power
switch board.
(See Fig.24 and 25)
attaching the power
attaching the power
(See Fig.27)
Rear panel
Fig.24
CN911,CN912
L
M
L
Power board
L
Fig.25
Mainboard
N
Fig.26
IC board
S
Fig.27
E E
CN913 Spacer
CN914
N
N
CN706
R
Power switch board
O
O
LED board
TH-A10
1-11