JVC TH-A10 Service Manual page 12

TH-A10
Removing the eject board (See Fig.28)
1. Disconnect the harness from connector CN702 on
the eject board.
2. Remove the three screws P
board.
Removing the LCD board (See Fig.29)
1. Remove the four screws Q attaching the LCD board.
2. Unsolder WA701, WA703 and WA704 on the LCD
board.
Removing the IC board (See Fig.27)
1. Remove the screw R attaching the IC board.
2. Disconnect the harness from connector CN706 on
the IC board.
Removing the LED board (See Fig.27)
Prior to performing the following procedure, remove
the LCD board and the IC board.
1. Disconnect the harness from connector CN705 on
the power switch board.
2. Remove the two screws S attaching the LED board.
Removing the switch board (See Fig.28)
Prior to performing the following procedure, remove
the LCD board.
1. Disconnect the harness from connector CN702 on
the eject board.
2. Remove the two screws T
board.
1-12
attaching the eject
attaching the switch
Eject board
Switch board
P
CN702
Fig.28
Q
LCD board
WA701
Q
Fig.29
R
IC board
S
Fig.27
T
Q
WA704
WA703
Q
CN706
Power switch board
O
O
LED board