TH-A10
Removing the traverse mechanism unit (refer to Figure 5)
o Remove the loading tray.
1. Remove the three screws at B fixing the traverse
mechanism unit.
Protecting the optical pickup
o Solder the flexible ground point on the optical pickup
when replacing the pickup or before detaching the
mechanism control board. When assembling the unit,
remove the solder last.
Removing the mechanism control board
(refer to Figures 6 - 7)
o Remove the traverse unit. (Can be detached without
detaching the T-mechanism unit.)
1. Remove the two screws at C fixing the mechanism
control base from the bottom of the traverse unit.
2. Pull out the CN12 connector and detach the
mechanism control board.
3. Remove the card wire from the CN13 connector
on the mechanism control board.
4. Pull out the FPC holder from the CN12 connector
on the reverse side of the mechanism control board
and remove the flexible harness, referring to Figure 7.
1-14
B
Enlargement
Connection area
(Solder the flexible
ground point)
Flexible harness
3
Enlargement
FPC holder
Figure 7
Traverse mechanism unit
B
Figure 5
Traverse mechanism unit
CN12
Mechanism control board
Figure 6
Flexible harness
2
1
CN12
Mechanism control board
B
C
CN13