Table of Contents
Advertisement
Fig. 2=3: Wheel in FREEWHEEL position
STEP 4: INSTALL FORWARD
CLUTCH CABLE
1. Attach the forward clutch cable bracket
(P, Fig. 2-4) to the handlebar support AI
with a 1/4"-20 x 1-1/4" hex hd. screw (R)
and 1/4"-20 hex Iocknut (S). Tighten se-
curely.
2. Carefully unwrap the forward clutch ca-
ble (cable without an attached knob, from
its shipping position and slide the thin ca-
ble wire (T, Fig. 2-4) into the slot in the ca-
ble bracket. Push the cable connector (U,
Fig. 2-4) up through the hole in the bracket
until the groove in the connector snaps
into place.
3. Insert the #10-24 x 2" slotted hd. screw
(V, Fig. 2-5) down through the hookedend
of the cable spring (W) until the screw
Fig.2.2: Atlach handlebar ( 5.5 HpMOde! shown),
threads extend thr0ugh the spring.
2. Removethe hairpin cotter (L, Fig. 2-3)
and wheel drive pin (M) from the wheel
hub (0) and wheel shaft (N).
3. Slidethe wheelfully inward on the wheel
shaft (N, Fig. 2-3). Reinstall the wheel
drive pin (M) through the wheel shaft only
(not through the wheel hub). Securethe
wheel drive pin with the hairpin cotter (L),
pushing the hairpin cotter in asfar as it will
go. The wheel should now spin freely
(freewheel) on the wheel shaft. Repeat
with the other wheel.
4. Usethe handlebarto roll the tiller to a
flat area.
IMPORTANT: Before Starting the engine,
the wheels must be placedin the WHEEL
Fig.2-4. Installing forward clutch cablebracket a ndcable.
DRIVEposition (pins through wheel hubs
and wheel shaft). This procedure is
described in WheelDrive Pins in Section 3.
Hide quick links:
Advertisement
Table of Contents
