Troy-Bilt 1030 Operator's Manual page 26

Safety & Decorative Labels
777 I22378
DRIVE
AUGER
LOCK
777S32066
FRONT TOP OF AUGER HOUSING
CUT FOOT PICTORIAL FACING
AWAY FROM OPERATOR
TOOL CLEAN-OUT
DANGER
MANUAL. OPERATOR'S READ 5.
SURFACES. GRAVEL
ON OPERATING WHEN CAUTION EXTRA USE
BYSTANDERS. AT DISCHARGE DIRECT NEVER
INJURIES, OBJECTS THROWN AVOID TO 4.
MACHINE. SERVICING OR UNCLOGGING
BEFORE STOPPED HAVE PARTS MOVING
ALL UNTIL HANDLES BEHIND REMAIN AND
ENGINE, STOP LEVERS, CLUTCH DISENGAGE 3.
CHUTE. DISCHARGE
UNCLOG TO TOOL CLEAN-OUT USE 2.
FEET. AND HANDS AMPUTATE CAN AUGER
OR IMPELLER WITH CONTACT AUGER. AND AVOID INJURY FROM
IMPELLER ROTATING FROM AWAY KEEP 1.
ROTATING AUGER -
DANGER
KEEP HANDS, FEET
AND CLOTHING AWAY.
777D03165
On each handle
grip
?
REF. 777S32236
MOLD-IN GRAPHIC
DANGER
NEVER PUT HAND IN CHUTE. CONTACT WITH
ROTATING PARTS CAN AMPUTATE FINGERS
AND HANDS.
SHUT OFF ENGINE AND WAIT UNTIL ALL
MOVING PARTS HAVE STOPPED BEFORE
UNCLOGGING.
USE CLEAN-OUT TOOL OR WOODEN STICK TO
UNCLOG DISCHARGE CHUTE.
26
OPERATORS VIEW
CHUTE DIRECTIONAL CONTROL
CHUTE TILT DOWN
PUSH BUTTON PUSH BUTTON
CHUTE ROTATE CHUTE ROTATE
LEFT RIGHT
CHUTE TILT UP
STARTING INSTRUCTIONS:
1.) INSERT IGNITION KEY AND SNAP IN
PLACE.
2.) SET CHOKE AND THROTTLE TO FULL (ON)
POSITION. PUSH PRIMER BUTTON 3x.
3.) ROPE START:
PULL SLOWLY UNTIL HARDER TO PULL,
THEN PULL RAPIDLY TO START. REPEAT
PRIMING IF NEEDED.
ELECTRIC START:
DO NOT USE IN RAIN. CONNECT POWER
CORD AND PUSH STARTER BUTTON.
REPEAT PRIMING IF NEEDED.
4.) MOVE CHOKE SLOWLY TO OFF POSITION.
TO STOP ENGINE: MOVE THROTTLE TO
5.)
STOP POSITION. LEFT TURN
AUGER
TRIGGER CONTROL
CONTROL
GO
777I22375
TOP EDGE OF SHROUD
FACING OPERATOR
ENGINE CONTROLS
RIGHT TURN
DRIVE
TRIGGER CONTROL DRIVE CONTROL
RIGHT TURN CONTROL CONTROL
SHEAR PIN
STORAGE
GO
777I22376
PLACE ABOVE IGNI T I ON
CUT-OUT
THROTTLE
FULLY
IGNITION INSERT
KEY
TO RUN
REMOVE TO
STOP CHOKE
OFF
FULL
(ON)
I22376
AC