Section 6: Troubleshooting - Troy-Bilt 1030 Operator's Manual

SECTION 6: TROUBLESHOOTING

Problem
Engine fails to start. 1. Fuel tank empty, or stale fuel.
2. Blocked fuel line.
3. Choke not in ON position.
4. Faulty spark plug.
5. Safety key not in ignition switch on engine.
6. Spark plug wire disconnected.
7. Primer button not being used properly.
8. Fuel shut-off valve closed. (If Equipped)
Engine runs erratic. 1. Unit running on CHOKE.
2. Blocked fuel line or stale fuel.
3. Water or dirt in fuel system.
4. Carburetor out of adjustment.
Loss of power. 1. Spark plug wire loose.
2. Gas cap vent hole plugged.
3. Exhaust port plugged.
Engine overheats. 1. Carburetor not adjusted properly.
Excessive vibration. 1. Loose parts or damaged auger.
Unit fails 1. Drive control cable in need of adjustment.
to propel itself.
2. Drive belt loose or damaged.
Unit fails 1. Chute assembly clogged.
to discharge snow.
2. Foreign object lodged in auger.
3. Auger control cable in need of adjustment.
4. Auger belt loose or damaged.
5. Shear pin(s) sheared.
NOTE: This section addresses minor service issues. For further details, contact an authorized service
center or call 1(800)520-5520 for assistance.
Cause
19
Remedy
1. Fill tank with fresh gasoline.
2. Clean the fuel line.
3. Move switch to ON position.
4. Clean, adjust gap or replace.
5. Insert the key fully into the switch.
6. Connect spark plug wire.
7. Refer to the engine manual.
8. Open fuel shut-off valve. (If Equipped)
1. Move choke lever to OFF position.
2. Clean fuel line and fill tank with clean,
fresh gasoline.
3. Drain fuel tank and carburetor. Refill
with fresh fuel.
4. Contact service center.
1. Connect and tighten spark plug wire.
2. Remove ice and snow from gas cap. Be
certain vent hole is clear.
3. Contact service center.
1. Contact service center.
1. Stop engine immediately and
disconnect spark plug wire. Tighten all
bolts and nuts. If vibration continues,
have unit serviced by an authorized
service center.
1. Adjust drive control cable. Refer to
Adjustments.
2. Replace drive belt.
1. Stop engine immediately and
disconnect spark plug wire. Clean
chute assembly and inside of auger
housing with clean-out tool or stick.
2. Stop engine immediately and
disconnect spark plug wire. Remove
object from auger with clean-out tool or
a stick.
3. Refer to Final Adjustments on page 6.
4. Refer to page 15.
5. Replace with new shear pin(s).