IBM R/S6000 7012 300 Series Operator's Manual page 104

System Response
The DIAGNOSTIC MODE SELECTION
menu is displayed.
The MISSING RESOURCE menu is
displayed.
The NEW RESOURCE menu is displayed.
The diagnostics begin testing a resource.
Note: If Problem Determination was
selected from the DIAGNOSTIC MODE
SELECTION menu, and if a recent error
has been logged in the error log, the
diagnostics will automatically begin testing
the resource.
Action
Select Problem Determination, and
then go to Step 13.
Follow the displayed instructions until
either the DIAGNOSTIC SELECTION
menu or an SRN is displayed.
If the DIAGNOSTIC SELECTION menu is
displayed, go to Step 13.
If you get an SRN, record it, and go to
Step 15.
If you get a number in the 3-digit display,
go to Step 14.
Follow the displayed instructions.
Note: Devices attached to serial ports S1
or S2 will not appear on the NEW
RESOURCE menu.
If the DIAGNOSTIC SELECTION menu is
displayed, go to Step 13.
If you get an SRN, record it, and go to
Step 15.
If you do not get an SRN, go to Step 19.
Follow the displayed instructions.
If the No Trouble Found screen is
displayed, press Enter.
If another resource is tested, repeat this
step.
If the ADVANCED DIAGNOSTIC
SELECTION menu is displayed, go to
Step 10.
If an SRN is displayed, record it, and go to
Step 15.
Hardware Problem Determination
6-9