Table of Contents
Related Manuals for Guardian G-Rail
Summary of Contents for Guardian G-Rail
-
Page 1: Table Of Contents
Product Name: G-Rail Part #: 15178; 15180; 15202; 15181; 15182; 15183; 15184; 15185 Instruction Manual Do not throw away these instructions! Read and understand these instructions before using equipment! Introduction Applicable Safety Standards Worker Classifications Product Specific Applications Components and Specifications... -
Page 2: Introduction
Introduction Thank you for purchasing a Guardian Fall Protection G-Rail. This manual must be read User Information and understood in its entirety, and used as part of an employee training program as required by OSHA or any applicable state Date of First Use: agency. -
Page 3: Product Specific Applications
Guardian Fall Protection G-Rail. Powder-coated yellow. 15202 12’ Guardian Fall Protection G-Rail. Powder-coated yellow. Baseplates: SOLD SEPARATELY from G-Rail Systems. Baseplate part #s 15178 and 15180 are compatible with G-Rail Systems. No toeboard attachments required. Toeboard attachments Use toeboard slots on baseplate for required for toeboard correct toeboard installation. -
Page 4: Installation And Use
Installation and Use Requirements for guardrail systems: MAXIMUM permitted roof pitch is 1/12 (5°). Toprails must be 42” (+/- 3”) above the work surface or, if used in stilt work applications, 42” plus the height of stilts. Midrails must be installed halfway between the top edge of the guardrail system and the working level (not the toeboard). - Page 5 2. Never install G-Rail Systems on top of gravel or other loose or slippery surfaces. 3. G-Rail Systems must be installed a MINIMUM of 10’ from power lines and all other electrical hazards. 4. Lay out the job by measuring and spacing the work surface and the selected baseplates. Baseplates must be at least 24”...
-
Page 6: Maintenance, Cleaning, And Storage
Cleaning after use is important for maintaining the safety and longevity of G-Rail. Remove all dirt, corrosives, and contaminants from G-Rail before and after each use. If G-Rail cannot be cleaned with plain water, use mild soap and water, then rinse and wipe dry. NEVER clean G-Rail with corrosive substances. -
Page 7: Safety Information
Safety Information Failure to understand and comply with safety regulations may result in serious injury or death. Regulations included herein are not all-inclusive, WARNING are for reference only, and are not intended to replace a Competent Person’s judgment or knowledge of federal or state standards. Do not alter equipment. -
Page 8: Labels
CAUTION Instruction cards MUST ALWAYS remain attached to EACH 6’/8’/10’/12’ G-Rail. DO NOT USE if instruction cards are not present. PRIOR TO USE, read and fully understand all instructions included with the equipment at time of shipment from the manufacturer. All users must be fully trained with the instructions for proper use of G-Rail Systems.