Hilti AG 230-27DB Original Operating Instructions page 25

3 Description
3.1 Product overview
Arbor lockbutton
@
Threaded bushing for handle
;
Steadying rib
=
On/off switch
%
Safety trigger
&
Side handle
(
Pin wrench
)
Clamping nut
+
3.2 Intended use
The product described is a hand-held electric angle grinder. It is designed for cutting and grinding metal and
mineral materials without use of water. It may used only for dry cutting / grinding.
The tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type plate.
• The power tool may be used for cutting, slitting and grinding mineral materials only when equipped with
the corresponding guard (optional accessory).
• A dust removal hood together with a suitable Hilti vacuum cleaner must be used for working on mineral
materials such as concrete or stone.
3.3 Items supplied
Angle grinder, guard, side handle, clamping flange, clamping nut, wrench and operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.group
3.4 Starting current limitation
The electronic starting current limiter reduces the starting current drawn by the power tool and thus prevents
the mains fuse blowing. It also allows the power tool to start smoothly, without a jolt.
3.5 Constant-speed electronics
Electronic speed control keeps running speed almost constant irrespective of whether the power tool is
idling or running under load. Constant running speed helps ensure maximum efficiency.
3.6 Active Torque Control (ATC)
The electronics detect potential stalling of the disc and prevent further rotation of the arbor by switching off
the tool.
If the ATC system has been triggered, restart the tool. Do this by releasing the on/off switch and then
pressing it again.
Note
If the ATC system malfunctions, the power tool will run only at greatly reduced speed and with greatly
reduced torque. Have the tool checked by Hilti Service.
3.7 Integrated brake
The integrated brake reduces the time it takes until the accessory tool stops rotating after switching off.
Note
This functions correctly only as long as the power tool is connected to the electric supply.
3.8 Current-dependent overload protection
The current-dependent motor overload protection system monitors current input and thus protects the tool
from overloading.
Printed: 26.09.2017 | Doc-Nr: PUB / 5376157 / 000 / 00
1
Kwik lock clamping nut (optional)
§
Cutting disc
/
Guard
:
Clamping lever
∙
Adjusting screw
$
Arbor
£
Clamping flange (attached to the power
|
tool)
Unlocking button (for pivotable grip)
¡
English 19