Dust Extraction - Bosch GSR18V-535FC Operating/Safety Instructions Manual

2610055572 GSR18V-535FC 01-2020.qxp_GSR18V-60FC 1/28/20 8:40 AM Page 20
Dust port adaptors are also available to
connect the Bosch dust extraction attachment
to any common size dust extractor hose. See
Boschtools.com for details.
Turn the dust extractor on and place the
attachment on the wall (or the floor), over the
desired drilling location so that the center of
the hole lines up with the center of the
opening of the brush ring. Note: the suction
from the dust extractor will hold the
BRUSH
RING
DUST
PORT
SNAP-IN
CONNECTOR
20

Dust Extraction

DUST
EXTRACTION
UNIT
DUST
EXTRACTOR
SAVE THESE INSTRUCTIONS
attachment in place on the work surface. Place
the drill bit through the opening in the brush
ring in the desired drilling location and drill the
desired hole (Fig. 20). Follow all tool safety
and operating instructions.
Note: for best results, continue running the
tool even when removing the bit from the hole.
The combination of the vacuum with the
spinning motion of the bit helps remove a
majority of the dust from the hole.
IG. 19 IG. 20
SLEEVE
NOZZLE
CONNECTOR