Bosch GSR18V-535FC Operating/Safety Instructions Manual page 12

2610055572 GSR18V-535FC 01-2020.qxp_GSR18V-60FC 1/28/20 8:40 AM Page 12
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
▶ Mounting and Removing Adapters
Make sure
1
screwdriver or drill bits in the main hex
drive 1 in Fig. 3 below. To remove a bit,
push locking sleeve 2 back and pull the
bit out.
Insert the hex shaft of an adapter into
2
the drive 1 and push the adapter,
turning
counterclockwise, until there is no gap
FIG. 3
2
▶ Rotating Right Angle and
Offset Adapters
The right angle adapter 13 and offset
adapter 12 (Fig. 1) can be rotated to any
position around the axis of the tool in 9°
increments. See Fig. 5.
Make sure the adapter is locked on the
tool.
1 Pull the adapter away from the lock
ring 15 approximately 3/16" (5mm).
Rotate the adapter to a desired
2
position.
3 Release the pull and let the adapter
return to the locked position.
12
Disconnect battery pack from tool before making any assembly,
that there are
it clockwise
2
1
1
3
15
SAVE THESE INSTRUCTIONS
between the clutch ring and the
locking ring on the adapter, and the
adapter snaps in place.
no
3 Lock the adapter in place by turning
the lock ring 15 in the direction shown,
towards the lock symbol, until it clicks
(Fig. 3).
To remove any adapter, turn the lock
4
ring 15 in the direction shown (towards
and
the unlock symbol) until it clicks. Pull
the adapter away from the tool (Fig. 4).
FIG. 4
4
FIG. 5
13
3
15
x .
m a
15