Bosch GSR18V-535FC Operating/Safety Instructions Manual page 15

2610055572 GSR18V-535FC 01-2020.qxp_GSR18V-60FC 1/28/20 8:40 AM Page 15
▶ Adjusting the Drilling Depth
(GFA18-H Hammer Adapter –
Sold separately)
The desired drilling depth X can be
specified with the depth stop (Fig. 12).
1 Insert the SDS drilling bit into the
Hammer Adapter, see "Inserting and
Removing SDS Bits" on page 14.
Press the depth stop locking tab 17,
2
located on the outside of the depth
stop holder, to allow movement of the
of the depth stop in the holder.
3 While pressing the locking tab, move
the depth holder until the tip of the
depth stop is placed behind the tip of
the bit, and the distance between the
two tips is equal to the desired drilling
depth "X" as shown in Fig. 12.
▶ Belt Clip
position yourself to avoid entanglement
with surrounding objects.
entanglement could cause the tool to fall
resulting in injury to the operator or
bystanders.
The belt clip 18 will allow you to
conveniently attach your tool to your belt
(Fig. 1). This feature will allow you to have
both hands free when climbing a ladder or
moving to another work area.
The belt clip can be attached to either side
of the tool by securing it with a mounting
screw. Always make sure you securely
tighten the mounting screw before use.
To use clip, turn tool upside down and
attach to your belt.
When the tool
attached to the belt,
Unexpected
SAVE THESE INSTRUCTIONS
FIG. 12
1
3
▶ 4X Bit Tip Holder
is
bits could interfere with proper tool operation
and result in user injury.
The four piece bit tip holder can be used for
convenient on tool storage of your most
commonly used bits.
1 When mounting bit holder accessory,
mount on the side of the drill opposite
the belt clip.
Always make sure you securely tighten
2
the mounting screw before use. (Fig.
13).
2
17
X
Store only bit tips in the
on-tool bit holder. Longer
FIG. 13
BIT HOLDER
15