Complete The Installation; Care And Cleaning - Kohler K-819 Installation And Care Manual

Freestanding bath
Hide thumbs Also See for K-819:
Table of Contents

Advertisement

Available languages

Available languages

Check for level.

5. Complete the Installation

CAUTION: Risk of property damage. A watertight seal must exist on all bath drain connections.
The watertight seal will prevent property damage.
NOTE: When installed, the wooden float is designed to leave a 1/8" (3 mm) gap between a level finished
floor and the float. This gap allows access to the adjustable feet for leveling the bath.
Connect the Plumbing
Connect the trap to the drain.
Install the bath faucet according to the faucet manufacturer's instructions.
Open the hot and cold water supplies. Check all connections for leaks.
Run water into the bath. Check the drain connections for leaks.
Level the Bath
Lift the float to access the leveling bolts at the bottom of the four adjustable feet.
Using the wrench provided, turn the leveling bolts to adjust the height.
Verify the bath is: (1) level across the top of the bath, (2) plumb along the drain side, and (3) resting
on all four feet.
Level the Float
Lift the float and turn the leveling bolts with your fingers. Adjust the four leveling bolts until
spacing between the bath and the float is uniform around the entire bath.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface after
each use.
• Use a soft nylon brush on Safeguard
(dissolves 100% in water).
1208000-2-A
1/8"
(3 mm)
Gap
Float
Finished Floor
slip-resistant surfaces. Be sure to use a water-soluble cleaner
®
6
Leveling
Bolt
Wrench
Kohler Co.

Advertisement

Table of Contents
loading

This manual is also suitable for:

K-894

Table of Contents