Service-13-7 Linear Actuator Repair (Automatic Version Only); Service-13-8 Gas Spring Repair (Manual Version Only) - Invacare Scorpius Series Service Manual

Scorpius Service Manual

2.13.7 SERVICE-13-7 Linear Actuator Repair (Automatic Version Only)

Please refer to SERVICE-13-6 Sliding Base Repair.
1. Locate the linear actuator and sliding base fastening point at the top end of the linear actuator.
2. Use an Allen driver (#5) to remove the holding screw (40 mm, 1pc).
3. The linear actuator can then be separated from the sliding base.
❖ When replacing the unit, follow the same sequence of steps in reverse.

2.13.8 SERVICE-13-8 Gas Spring Repair (Manual Version Only)

Please carry out the SERVICE-13 Frame Repair, SERVICE-13-1 Solenoid Valve Repair, SERVICE-13-2
Folding Unit Repair (Manual Only) and SERVICE-13-6 Sliding Base Repair steps and then:
1. Locate the gas spring and sliding base at the top end of the gas spring.
2. Use an Allen driver (#5) to remove the holding screw (40 mm, 1 pc).
3. The gas spring can then be separated from the sliding base.
❖ When replacing the rod, follow the same sequence of steps in reverse.
❖ To install a new gas spring, the rubber sleeve on top of the gas spring needs to be removed to prevent
abnormal actuation during folding or unfolding.
1654773~A 57