Service-11-2 Taillight Repair - Invacare Scorpius Series Service Manual

Scorpius

2.11.2 SERVICE-11-2 Taillight Repair

Follow the Service Procedures SERVICE-01 Steering Shroud Repair
steps, then:
1. Find the main cable connector (see picture on the right).
2. Check the connector for security and reconnect if necessary (picture
on the right).
3. If this does not restore function, refer to the following method.
Please follow the SERVICE-11 Rear Top Shroud Repair steps for removal,
then:
1. Find the taillight connector (figure on the right).
2. Check the connector for security and reconnect if necessary (figure on
the right).
3. If this is not effective, go to the following Replacement Instructions.
Replacement Instructions:
Please follow the SERVICE-11 Rear Top Shroud Repair steps for removal, then:
1. Locate the taillight at the rear of the scooter.
2. Remove the two screws holding the rear shroud.
3. Take out the taillight and replace it with a new one.
❖ When reassembling, please follow the exact reverse sequence of these steps.
❖ If this does not restore function, refer to: SERVICE-01-1 Top Control Panel Repair or SERVICE-11-1 DR
Controller Repair to replace a faulty board.
1654773~A
Service Manual
40