Service-12 Rear Lower Shroud Repair - Invacare Scorpius Series Service Manual

Scorpius

2.12 SERVICE-12 Rear Lower Shroud Repair

Please follow the SERVICE-11 Rear Top Shroud Repair steps for removal, then:
1. Remove the rear top shroud and find the cable ties on both sides.
2. Cut and remove the cable ties on the wires on both sides.
3. and
4. Unplug all the connectors on the rear lower shroud and DR controller.
5. Locate the four screws (12 mm, 4 pcs) holding the bottom of the rear lower shroud.
6. Remove the four screws.
7. Open the rear lower shroud and tear off the solenoid valve tape on both sides.
8. Disengage the solenoid valve connectors on both sides and disconnect the lower shroud hook.
9. Take the shroud off.
❖ When reinstalling, please carry out these steps in the exact reverse sequence. Please also refer to the
Cautions on the next page.
❖ For relevant connectors, please refer to the instructions on the next page.
• Re-installation of the lower shroud is more complicated because incorrect connections will
cause malfunction. Please refer to the re-installation instructions on the next page.
• Steps 3 and 4. For connector positions and instructions, please refer to the instructions in
SERVICE-11 Rear Top Shroud Repair.
1654773~A
Service Manual
44