Snmp Server; Syslog Server - ATEN RCM101D User Manual

Log Server
Important transactions that occur on the RCM101D, such as logins and internal
status messages, are kept in an automatically generated log file
 Specify the MAC address of the computer that the Log Server runs on in
the MAC address field.
 Specify the port used by the computer that the Log Server runs on to listen
for log details in the Port field. The valid port range is 1–65535. The
default port number is 9001.
Note: The port number must different than the one used for the Program
port (see Service Ports, page 35).
See Chapter 8, The Log Server, for details on setting up the log server. The Log
File is discussed on page 97.

SNMP Server

To be notified of SNMP trap events, do the following:
1. Check Enable SNMP Agent.
2. Key in the IP address and the port number of the computer to be notified of
SNMP trap events. The valid port range is 1-65535. Default is 162.
Note: The following SNMP trap events are sent: System Power On, Login
Failure, and System Reset.

Syslog Server

To record all the events that take place on the RCM101D and write them to a
Syslog server, do the following:
1. Check Enable.
2. Key in the IP address and the port number of the Syslog server. The valid
port range is 1-65535. Default is 514.
Chapter 4. Configuration
39