[Operation Setting] - Panasonic PT-MZ16K Operating Instructions Manual

g When pressing the <SHUTTER> button on the remote control or the control panel to make the shutter closed (shutter: closed)
g When changing the shutter function from disabled (shutter: opened) to enabled (shutter: closed) using the [DISPLAY OPTION] menu →
[SHUTTER SETTING] → [STARTUP]
g When the light source is turned off by the no signal lights-out function
g When faded out during shutter function operation
g When the lens temperature sensor error is displayed
f When [ACTIVE FOCUS OPTIMIZER] is set to [ON] and the [DISPLAY OPTION] menu → [SHUTTER SETTING] → [STARTUP] is set to
[CLOSE], the [ACTIVE FOCUS OPTIMIZER] function will not be executed when the power is turned on the next time.
f The [ACTIVE FOCUS OPTIMIZER] function operates within the range of focus adjustment. It may not operate properly when used close to
the limit value for the focus adjustment.
f Execute [LENS CALIBRATION] when the projection lens is replaced.
The [ACTIVE FOCUS OPTIMIZER] function will not operate correctly if [LENS CALIBRATION] is not executed.
f When an initialization is executed by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET], [ACTIVE FOCUS
OPTIMIZER] will be set to [OFF].

[OPERATION SETTING]

Set the operation method of the projector.
The settings are reflected when "Initial setting (operation setting)" (x page 58) in the [INITIAL SETTING]
screen is already set.
If you change the settings while using the projector, the duration until the brightness decreases to half may
shorten or the brightness may decrease.
Setting [OPERATING MODE]
1) Press as to select [OPERATION SETTING].
2) Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3) Press as to select [OPERATING MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[QUIET]
[USER1]
[USER2]
[USER3]
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
and is not the warranty period.
5) Press as to select [APPLY].
6) Press the <ENTER> button.
f The confirmation screen is displayed.
7) Press qw to select [OK], and press the <ENTER> button.
Note
f The estimated runtime is a time for the luminance to decrease to half.
f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
Setting [LIGHT OUTPUT]
Adjust the brightness of light source.
The [LIGHT OUTPUT] setting is synchronized with the [PROJECTOR SETUP] menu → [LIGHT OUTPUT]. The
most recent setting is reflected in both items.
1) Press as to select [OPERATION SETTING].
2) Press the <ENTER> button.
f The [OPERATION SETTING] screen is displayed.
3) Press as to select [LIGHT OUTPUT].
126 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Set this item when the brightness is required. The estimated runtime is approximately 20 000 hours
The brightness will decrease compared to [NORMAL], but select this item when operation with low
noise is prioritized. The estimated runtime is approximately 20 000 hours
Set [LIGHT OUTPUT] as desired.
.
*1
dust. The value of runtime is just an estimate,
3
.
*1