[Lens] - Panasonic PT-MZ16K Operating Instructions Manual

[CEILING]
Note
f Refer to "Angle sensor" (x page 35) for details on the range of the installation attitude that can be detected by the built-in angle sensor.

[LENS]

Perform the setting and operation regarding the projection lens.
[LENS TYPE]
When the projection lens is attached or replaced, confirm the [LENS TYPE] setting.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Confirm the type of the projection lens in [LENS TYPE].
Note
f The information of the projection lens is automatically acquired when the projector is turned on. The acquired information is displayed in
[LENS TYPE].
f [---] is displayed in [LENS TYPE] in following cases.
g When the automatic acquiring of the projection lens information has failed
f The [ACTIVE FOCUS OPTIMIZER] function will not operate when the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS
OPTIMIZER] is set to [ON] and [---] is displayed in [LENS TYPE].
f Turn off the projector and reattach the projection lens when [---] is displayed in [LENS TYPE].
[LENS HOME POSITION]
Operate in following procedure to move the projection lens to the home position.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS HOME POSITION].
4) Press the <ENTER> button.
f The confirmation screen is displayed.
5) Press qw to select [OK], and press the <ENTER> button.
f The projection lens is moved to the home position.
Note
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
f [---] is displayed in the confirmation screen for execution of the lens home position in following cases.
g When the automatic acquiring of the projection lens information has failed
f The projection lens is not moved to the correct home position when the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION]
is not executed.
f If the projection lens was replaced, execute the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION].
f The home position does not match with the optical image center position.
f The home position varies depending on the projection lens type. Refer to "Lens shift range" (x page 71) for details.
f [LENS HOME POSITION] can also be executed by pressing the <DEFAULT> button on the remote control while the lens shift adjustment
screen is displayed.
[LENS CALIBRATION]
Detect the lens adjustment limit value, and perform the calibration in the adjustment range.
Execute the lens calibration after attaching the projection lens.
1) Press qw to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
124 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Select this item when installing the projector using the Ceiling Mount Bracket (optional).
Projected image is inverted upside down.