[Function Button]; [Filter Counter] - Panasonic PT-MZ16K Operating Instructions Manual

[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[OSD POSITION]
4) Press the <ENTER> button.

[FILTER COUNTER]

Check the runtime of the filter and set the cleaning/replacement cycle of the filter. Also, the runtime of the filter can
be reset.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
[FILTER COUNTER]
[TIMER]
[FILTER COUNTER RESET]
Setting [TIMER]
If the filter is to be cleaned/replaced periodically, set the cycle in hours. Once the runtime of the filter reaches
the set time, a message prompting to clean/replace the filter [FILTER COUNTER has reached the set time.] is
displayed on the projected image.
1) Press as to select [FILTER COUNTER].
2) Press the <ENTER> button.
f The [FILTER COUNTER] screen is displayed.
3) Press as to select [TIMER].
140 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Uses pin assignment of the <REMOTE 1 IN> terminal in standard setting. (x page 227)
Changes the setting of the <REMOTE 1 IN> terminal.
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 150)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than the SDI input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 86)
f When the input signal is the SDI input
The [DISPLAY OPTION] menu → [SDI IN] → [SYSTEM SELECTOR] (x page 110)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 84)
Freezes the image temporarily. (x page 120)
Displays the waveform of the input signal. (x page 120)
Switches the aspect ratio of the image. (x page 88)
Switches the [PROJECTION METHOD] setting. (x page 123)
Switches the [GEOMETRY] setting. (x page 90)
Switches the [OSD POSITION] setting. (x page 113)
Displays the runtime of the filter.
Sets the cleaning/replacement cycle of the filter.
Reset the runtime of the filter.